Procedure for the Site Assembly and Installation of Three Tread Step Flight
Table of Contents
Preparation Notes
- This procedure requires a minimum of two suitably qualified and competent personnel at all times.
- The installation team should ensure that they are fully conversant with all aspects of this procedure and the detailed assembly diagrams overleaf prior to the commencement of work.
- The installation team should ensure that safe handling techniques are adopted at all times.
- Alsim System Building Limited will not be held responsible for any incident, accident, or injury resulting from the installation of a landing, staircase, or related item, as described herein.
Suggested Basic Safety Equipment
Suggested Basic Safety Equipment
- Safety Boots
- High Visibility Clothing
- Hard Hat
- Protective Gloves suited to this application
- Safety Eyewear
Tools & Equipment Required
Tools & Equipment Required
- Crane or HIAB
- Socket Set to suit fixings listed below
- Spirit Level
Parts Check List
- Staircase Assembly, item 1 (x1)
- Handrail Assembly, item 2 (x2)
- M12 x 30mm M/S Bolt (x4)
- M12 Flat M/S Washer (x4)
Step by Step Instructions
- Install the units as outlined in the relevant procedure.
- Fit both Handrails (Item 2) into locating sockets on the outer side of Staircase Assembly (see Figure 2) and secure by tightening the pre-installed bolts.
- Lift Staircase Assembly (Item 1) into position using a suitable crane or HIAB.
- Align Staircase Assembly (Item 1) to the unit’s integrated staircase bracket (see Figure 3). Secure using the designated fixings.
- Ensure the Landing is level using a spirit level prior to final fixing.
- See Figure 1 for a complete staircase.
Image
