Procedure for the Site Assembly and Installation of 1260mm x 1200mm Single Exit Landing and 3 Tread Step Flight
Table of Contents
Preparation Notes
- This procedure requires a minimum of two suitably qualified and competent personnel at all times.
- The installation team should ensure that they are fully conversant with all aspects of this procedure and the detailed assembly diagrams overleaf prior to the commencement of work.
- The installation team should ensure that safe handling techniques are adopted at all times.
- Alsim System Buildings Limited will not be held responsible for any incident, accident or injury, resulting from the installation of a landing, staircase or related item, as described herein.
Suggested Basic Safety Equipment
Suggested Basic Safety Equipment
- Safety Boots
- High Visibility Clothing
- Hard Hat
- Protective Gloves suited to this application
- Safety Eyewear
Tools & Equipment Required
Tools & Equipment Required
- Crane or HIAB
- Ladder
- Socket Set to suit fixings listed below
- Spirit Level
Parts Check List
Staircase Assembly, item 1 (x1)
Landing Support Leg, item 2 (x2)
Landing Platform Assembly, item 3 (x1)
Handrail Assembly, item 4 (x2)
Landing Handrail Assembly, item 5 (x2)
M12 x 80mm M/S Bolt (x2)
M12 x 50mm M/S Bolt (x3)
M12 x 30mm M/S Bolt (x4)
M12 M/S Nut (x5)
M12 Flat M/S Washer (x14)
Step by Step Instructions
- Install the units as outlined in the relevant procedure.
- Fit both items of the Landing Handrail Assembly (Item 5) into the locating sockets on Landing Platform (Item 3), ensuring the kick plates are on the inside of the landing (see Figure 2). Secure by tightening the pre-installed bolts.
- Using a suitable crane or HIAB, lift the Landing Assembly (created by step 2) and insert both Landing Support Legs (Item 2) into the locating sockets (see Figure 3). Please note that the Landing Support Legs are adjustable to suit ground conditions.
- Position Landing Assembly and Landing Support Legs (created by steps 2 & 3) to align with the units integrated staircase bracket (see Figure 5). Designated fixings are used to secure the landing to the staircase bracket.
- Ensure the Landing is level using a spirit level prior to final fixing.
- Secure both Landing Support Legs (Item 2) into position using designated fixings (see Figure 3).
- Fit both Handrails (Item 4) into locating sockets on the side of the Staircase Assembly (see Figure 4) and secure by tightening the pre-installed bolts.
- Lift Staircase Assembly (Item 1) into position using a suitable crane or HIAB.
- Locate Staircase Assembly (Item 1) to the Landing Platform Assembly (Item 3). Secure using the designated fixings (see Figure 6).
- See Figure 1 for complete staircase landing assembly.
Image
